فرستنده FERESTANDEH 5MM

Features

˙High reliability
˙High radiant intensity
˙Peak wavelength λp=940nm
˙2.54mm Lead spacing
˙Low forward voltage
˙Pb free
Descriptions
˙HYLED Infrared Emitting Diode is a
high intensity diode, molded in transparent plastic package
˙The device is spectrally matched with phototransistor, photodiode
and infrared receiver module
Usage Notes:
˙Surge will damage the LED
˙When using LED, it must use a protective resistor in series with DC current about 20mA
Applications
˙Free air transmission system
˙Infrared remote control units with high power requirement
˙Smoke detector
˙Infrared applied system

Device Selection Guide
Chip
LED Part No.
Material Emitted Color
Lens Color
5010IRC940-H AlGaAs Infrared Water clear
Package Dimensions
Notes:
˙Other dimensions are in millimeters, tolerance is 0.25mm except being specified.
˙Protruded resin under flange is 1.5mm Max LED.
˙Bare copper alloy is exposed at tie-bar portion after cutting.

Absolute Maximum Rating (Ta=25)
Parameter Symbol Absolute Maximum Rating Unit
Forward Pulse Current IFPM 100 mA
Forward Current IFM 30 mA
Reverse Voltage VR 5 V
Power Dissipation PD 140 mW
Operating Temperature Topr -40 +80
Storage Temperature Tstg -40 +100
Soldering Heat (5s) Tsol 260
Electro-Optical Characteristics (Ta=25)
Parameter Symbol Min. Typ. Max. Unit Test Condition
Radiant intensity Ee — 12 — mW/Sr IF=20mA(Note1)
Viewing Angle 2θ1/2 20 — 30 Deg (Note 2)
Peak Emission Wavelength λp — 940 — nm IF=20mA
Spectral Line Half-Width △λ 15 20 25 nm IF=20mA
Forward Voltage VF 1.2 — 1.5 V IF=20mA
Reverse Current IR — — 10 µA VR=5V
Note:
1. Luminous intensity is measured with a light sensor and filter combination that approximates the CIE
eye-response curve.
2. θ1/2 is the off-axis angle at which the luminous intensity is half the axial luminous intensity.

Notes
1. Above specification may be changed without notice. SUNRISE LED will reserve authority on
material change for above specification.
2. When using this product, please observe the absolute maximum ratings and the instructions
for using outlined in these specification sheets. SUNRISE LED assumes no responsibility for
any damage resulting from use of the product which does not comply with the absolute
maximum ratings and the instructions included in these specification sheets.
3. These specification sheets include materials protected under copyright of SUNRISE LED
corporation. Please don’t reproduce or cause anyone to reproduce them without SUNRISE LED’s
consent.